Pairing the earbuds with a Bluetooth device (pairing via Bluetooth Classic)

If you have completely deactivated the control functions for Touch and Tap control via the Smart Control app (see page > Customizing the control functions): •​The earbuds can only be controlled via the Smart Control app and the connected Bluetooth device. •​If the earbuds are inserted into the ears (proximity sensors are triggered), pairing with another Bluetooth device is not possible. •​If you remove the earbuds from your ears, pairing with another Bluetooth device is possible as long as the proximity sensors are not triggered (e.g. by placing the earbuds on a tabletop or holding the earbuds in your hand).

1.​Take both earbuds out of the charging case and insert them into your ears (see page > Inserting the earbuds into the ears). The distance between the earbuds and the Bluetooth device should not exceed 40"/1 m.

2.​Simultaneously touch and hold the right and the left control panel for 3 seconds until you hear the voice prompt “Pairing” and a beep.

The LEDs of the earbuds flash blue and red. The earbuds are in pairing mode.   

3.​Activate Bluetooth on your Bluetooth device.

4.​Via the menu of your Bluetooth device, start the search for new Bluetooth devices.

All active Bluetooth devices in the immediate vicinity are displayed.

From the list of found Bluetooth devices, select “MOMENTUM Sport”. If necessary, enter the default pin code “0000”.

If pairing was successful, you hear the voice prompt “Pairing successful” and the LEDs of the earbuds flash blue 3x.

If no connection is established within 2 minutes, pairing mode is terminated (voice prompt “Pairing cancelled”) and the earbuds switch to idle mode. If necessary, repeat the steps described above. If the earbuds are not paired with any Bluetooth device (the pairing list is empty), pairing mode is permanently active.